Call Us +47 90916585

Welcome to Tuningtools // Sedox Store!

SpiderBOOT for CMD Flash

More Views

SpiderBOOT for CMD Flash

Availability: In Stock

Installation of SpiderBOOT for CMD Flash enables You to:
-read the locked ECUs over OBD port with even faster read out time
-lock the ECU so that no ne else can read or reprogram it so You can protect Your work
-easily reprogram the locked ECUs over OBD after a dealer update
For more informations please check out the product.


SpiderBOOT for CMD Flash

All protocols supported by CMDFlash TriCore BOOT are available on SpiderBOOT too.

SpiderBOOT is a small circuit to be fitted into electronic control units.

SpiderBOOT is provided with ahigh temperature, heatresistant adhesive insuring safe anchorage to the microprocessor.

SpiderBOOT terminals are configurable allowing the user to achieve the signals from the microprocessor in order to emulate BOOT equipments through the OBD diagnostic socket.


-Once installed and mounted, the ECU can be sealed with no need to re-open to make changes or to restore to the original software. This will insure and preserve ECU from any unwanted water infiltration.
-Read and write, possible on all areas: IROM/XROM/E2P
-Saving of control unit backup
-Writing Backup to restore the unit to its original
-The OBD programming counters are not incremented
-Invisible to the official diagnosis tools
-Recovery always possible.
-Rates of reading and writing reduced to a few minutes (always less than 5min)
-Checksum is automatic on calibration areas


Special Functions

Protection of files,SpiderBOOT has a setup menu that allows the tuner to choose between the following options: protection from OBD reading, OBD writing, restricted access to their ID. This allows you to avoid reading or unauthorized reprogramming, including manufactures settings. To ensure total protection you need to seal the unit so that no one can have access to it. This can be done by using NON acetic silicon or potting epossidic resins for electronic use.


SpiderBOOT can only be initialized once and can not be re-used for another ecu.

SpiderBOOT is currently available for TriCore Infineon, BDM version will soon be available for units equipped with Motorola processors 5xx.

SpiderBOOT supports the Master / Slave technology.

SpiderBOOT is a registered trademark of Flashtec SA

SpiderBOOT is PATENTED, protected by International Laws

Additional Information

Additional Information





There are no product questions yet.

Ask a question and Give an answer. Help your fellow customer.

Ask Your Question

* Required Fields

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.