CMD Plugin VAG counter SLAVE

CMD Plugin for the editing of Flash counting

Description of Counters protocol
EDC16 Vag group ECUs have two counters: the first counts OBD programming attempts, the
second counts the OBD successfully programming attempts.

How to use it?
Before modifyng the car you need to read Counters current values.
To modify the Counters you need to write inside the ECU a special patching code. It must be done
one time only.
To modify the firmware, proceed as follows:
-Connect your CMDFlash tool and select OBD TOOLS/VAG/Counters EDC16 XX
-Click “IDENTIFY”, read current values, click “CANCEL”.
-Click “READ” and save the current original ECU firmware in your archive.
This file SHOULD NOT be modified, it is a temporary file only necessary to reset the ECU in case
of failure during writing operation.
-Click “WRITE” and select the file previously read.
-Turn off the dashboard.
After this operation you can read and modify the car as usual.
Once the modification is finished, you can select the Counter protocol and click “IDENTIFY”.
Counters will be read again. Type in the previously read original values or the one you most desire
and press “OK”.